Check Point Certified Security Administrator 試験
Question No : 1
Which of the following describes the default behavior of an R77 Security Gateway?
Question No : 2
How can you activate the SNMP daemon on a Check Point Security Management Server?
Question No : 3
Spoofing is a method of:
Question No : 4
Anti-Spoofing is typically set up on which object type?
Question No : 5
How does the button Get Address, found on the Host Node Object > General Properties page retrieve the address?
Question No : 6
When you change an implicit rule’s order from Last to First in Global Properties, how do you make the change take effect?
Question No : 7
You are using SmartView Tracker to troubleshoot NAT entries. Which column do you check to view the NAT'd source port if you are using Source NAT?
Question No : 8
You are troubleshooting NAT entries in SmartView Tracker. Which column do you check to view the new source IP?
Question No : 9
SmartView Tracker R77 consists of three different modes. They are:
Question No : 10
While in SmartView Tracker, Brady has noticed some very odd network traffic that he thinks could be an intrusion. He decides to block the traffic for 60 minutes, but cannot remember all the steps. What is the correct order of steps needed to set up the block?
1) Select Active Mode tab in SmartView Tracker.
2) Select Tools > Block Intruder.
3) Select Log Viewing tab in SmartView Tracker. 4) Set Blocking Timeout value to 60 minutes. 5) Highlight connection that should be blocked.
Question No : 11
Which of the following R77 SmartView Tracker views will display a popup warning about performance implications on the Security Gateway?
Question No : 12
You are reviewing the Security Administrator activity for a bank and comparing it to the change log. How do you view Security Administrator activity?
Question No : 13
Which SmartView Tracker selection would most effectively show who installed a Security Policy blocking all traffic from the corporate network?
Question No : 14
How do you view a Security Administrator's activities with SmartConsole?
Question No : 15
Where are custom queries stored in R77 SmartView Tracker?