300-180 実際試験問題と解答 - 模擬練習 - 受験自信を増やす

Question No : 1
Which two statements about configuring a traffic monitoring session are true? (Choose two.)

A.You can set a local VM as a traffic destination.
B.You can have up to two active monitoring sessions simultaneously.
C.An unlimited number of monitoring session can be stored.
D.A newly created monitoring session is enabled by default.
E.A destination port can also be a source port within the same session.
F.A vHBA can be a source for either an Ethernet or Fibre Channel monitoring session, but not both.

正解:

Question No : 2
Which option causes an operating system on a UCS device to consistently crash several minutes after booting?

A.faulty power supply
B.out-of-date network adapter firmware
C.incompatible operating system driver
D.incorrect boot order
E.disabled trusted platform module

正解:

Question No : 3
Which three components are updated using the Host Upgrade Utility? (Choose three.)

A.BIOS
B.Network Adapter(s)
C.Array Controller
D.Cisco IMC
E.LOM port
F.UCSM
G.Drive Firmware

正解:

Question No : 4
Which option is a valid file extension for a CIMC configuration file?

A..xml
B..json
C..txt
D..exe
E..zip

正解:

Question No : 5
Which feature on the Cisco IMC GUI allows you to view the last boot post operation?

A.Firmware Management tab
B.Bootstrap Process Recording
C.Crash Recording
D.Trusted Platform Module

正解:

Question No : 6
Which statement about Cisco UCS version compatibility is true?

A.All bundles (A, B, and C) must be the same version.
B.The B and C bundles must be the same revision.
C.The A bundle can be one revision higher than the B/C bundles.
D.The B/C bundles can be one revision higher than the A bundles.

正解:

Question No : 7
Which option describes why the service profiles do not inherit changes from the template?

A.The service profile is not compatible with the changes.
B.The changes to the template have not been committed.
C.It is an initial template.
D.The service profile has disabled inheritance.

正解:

Question No : 8
Which power policy should be chosen to maximize the performance of a Cisco UCS system with four PSUs and eight blades?

A.non-redundant
B.N+1
C.grid
D.performance

正解:

Question No : 9
What is the correct procedure to change Ethernet switching modes?

A.Navigate to the subordinate Fabric Interconnect in the GUI, choose "Set Ethernet Switching mode", wait for it to come back up, and repeat on the primary F
B.Navigate to either Fabric Interconnect in the GUI, choose "Set Ethernet Switching mode", and wait while both FIs reboot simultaneously.
C.Navigate to either Fabric Interconnect in the GUI and transparently update the mode to switching. Repeat on the other Fabric Interconnect.
D.Simply start using the switching features. The Fabric Interconnect automatically reconfigures to use Ethernet Switching Mode.

正解:

Question No : 10
Where do you configure users so that they cannot access resources that belong to other
organizations?

A.roles
B.domain separation
C.locals
D.VDCs

正解:

Question No : 11
A UCS Admin is trying to launch the KVM console but it is failing to launch. All IP Pools for mgmt are configured and the CIMC has an address in UCSM. They SSH to the fabric Interconnect and run an ethanalyzer while issuing a ping from their local PC to the KVM IP address. The ping is successful but they do not see the ICMP requests and replies displayed in the capture.
Here is the filter they used:
FIA(nxos)# ethanalyzer local interface mgmt display-filter icmp limit-captured-frames 0
What could be the reason pings are not seen in the capture and the KVM is failing to load?

A.Java settings are preventing the KVM from loading
B.There is a duplicate IP address for that CIMC address
C.The switch upstream from the FI has the wrong vlan configured
D.The CIMC IP pool is in the same subnet as the Fabric Interconnects mgmt 0 interface

正解:

Question No : 12
Which logs are used to troubleshoot hardware failure?

A.system event log
B.audit log
C.accounting log
D.gateway logs
E.system log

正解:

Question No : 13
Which description of a core file is true?

A.It is generated by a system failure.
B.It is generated by a process failure.
C.It is generated by a component failure.
D.It is generated by a hardware failure.

正解:

Question No : 14
Which three requirements are needed to configure a blade to boot successfully from Fibre Channel? (Choose three.)

A.zoning
B.LUN masking
C.WWPN device alias
D.boot from SAN policy
E.SAN connectivity policy
F.port assignment
G.target WWPN needs to be set in the boot from SAN policy

正解:

Question No : 15
A Cisco UCS admin is trying to integrate Cisco UCS Manager with Active Directory Authentication. After the configuration is done, the admin is still unable to log in using LDAP credentials.
When running a debug on the Fabric Interconnect, this error is displayed:
ldap_build_roles_and_locales_from_attr: No attr for usr profile
Which step was missed in the configuration?

A.The LDAP provider was not configured correctly.
B.The proper RBAC role(s) were not assigned to the user.
C.Cisco UCS Manager 2.1 is required for LDAP integration.
D.The "Attribute" field in Cisco UCS was left blank.

正解:

Cisco 300-180 DCIT 問題練習