Nokia NRS II Composite Exam 試験
Question No : 1
Which of the following statements regarding the IS-IS CSNP is FALSE?
Question No : 2
Which of the following is the correct IPv6 interface identifier that is derived from the MAC address 00-164D-13-5C-AE?
Question No : 3
A service provider is deploying a 6over4 tunnel to connect a customer’s branch office IPv6 network to the corporate headquarters as shown in the exhibit.
Which command is used to create a default route on PE2 for the branch office network?
Question No : 4
Which of the following about Type 4 LSAs is FALSE?
Question No : 5
Given the output shown, which router is the ASBR in this network?
Question No : 6
Which router is the backup designated router for the broadcast network?
Question No : 7
Given the contents of the Router LSA, which of the following best describes the local topology of the router?
Question No : 8
Given the diagram below, what path will traffic follow from router R6 to router R3, and from router R3 to router R6, if IS-IS is the routing protocol? The numbers beside the links are the metrics for that link.
Question No : 9
What event causes an OSPF adjacency to change from 'down' to 'two way'?
Question No : 10
What type of OSPFv3 LSA is shown?
Question No : 11
Examine the physical topology of the IS-IS network, the metrics of the links and the levels of the routers. All routers have a system address included in IS-IS.
Which of the following describes the route that router R4 will use to reach the system address of router R6?
Question No : 12
Which of the following best describes the type of packets used by OSPF routers to exchange updates on a point-to-point link?
Question No : 13
Router R2 learns the networks shown from IS-IS. Router R2 is configured to redistribute routes from IS-IS to OSPF as shown.
How many OSPF Type 5 LSAs will router R1 receive from router R2? Assume the OSPF and IS-IS adjacencies are operational.
Question No : 14
OSPF is operational on all links in the network diagram, all links have the same cost and all routers are configured with an ECMP value of 4. Router R4 advertises the prefix 192.168.3.0/24 into OSPF.
How many entries for prefix 192.168.3.0/24 will be in router R1's routing table?
Question No : 15
192.168.3.1 is a loopback interface configured into router R2's OSPF area 0. A ping from router R3 to this loopback fails.
Which of the following is a possible solution to the problem?