640-692 実際試験問題と解答 - 模擬練習 - 受験自信を増やす

Question No : 1
What are two ways to open a command prompt session on a Windows-based computer? (Choose two)

A.Click Start > Control Panel > Command Prompt
B.Click Start > All Programs > Accessories > Command Prompt
C.Click Start > All Programs > Command Prompt
D.Click Start > Run. Enter cmd and click OK
E.Click Start > All Programs > Accessories > Communications > Command Prompt

正解:

Question No : 2
Which two commands are used to set the configuration register value? (Choose two)

A.Router(config)#config-register 0x2102
B.Router(config)#confreg 0x2102
C.rommon>config-register 0x2102
D.rommon>confreg 0x2102
E.Router(config)#configuration-register 0x2102

正解:

Question No : 3
Which two modules can be plugged into internal advanced integration module (AIM) slots on a Cisco router? (Choose two)

A.Virtual Private Network Module
B.Intrusion Detection System Module
C.Packet Voice Digital Signal Processor Module
D.LAN Switching Module
E.Voice Interface Module

正解:

Question No : 4
Which two pieces of information can be determined about a neighbor device from the CLI command show cdp neighbor? (Choose two)

A.device ID
B.IP address
C.platform
D.uptime

正解:

Question No : 5
Which type of memory is necessary for a router to boot?

A.DRAM
B.PVDM
C.NVRAM
D.VRAM

正解:

Question No : 6
What are two possible causes if an Ethernet interface is up and the line protocol is down? (Choose two)

A.The Ethernet cable might not be attached properly
B.There is a speed or duplex mismatch with the remote device
C.The Ethernet interface has been manually disabled
D.There is a Layer 2 mismatch in the encapsulation type
E.Keepalives are not being received by the local device

正解:

Question No : 7
Which of the following best describes the cable that is used to connect a laptop to the Console port on a Cisco router?

A.crossover
B.straight-through
C.fiber
D.rollover

正解:

Question No : 8
From a Windows command prompt, which command displays the local IP address of a computer?

A.ip config
B.ip configuration
C.ipconfig
D.ipconfiguration

正解:

Question No : 9
Which two of the following statements are true? (Choose two)

A.Because FTP usually requires authentication, a Cisco router must be configured with the appropriate username and password.
B.FTP uses UDP as its transport protocol.
C.The copy running-config ftp: command is used to copy a configuration file from an FTP server to the running configuration.
D.A router can act as an FTP server.
E.FTP can be used to load Cisco IOS software to router in ROMMON mode.

正解:

Question No : 10
Which command displays the configuration register setting?

A.show config-register
B.show flash
C.show running-config
D.show version

正解:

Question No : 11
Which two of the following are features of NVRAM on a Cisco device? (Choose two)

A.Stores startup configuration
B.Stores running configuration
C.Stores routing tables
D.Stores decompressed IOS software image
E.Erased when device is rebooted
F.Not erased when device is rebooted

正解:

Question No : 12
The colored wires at one end of the cable in the reverse sequence of the colored wires at the other end of the cable. Which cable does this describe?

A.Rolled
B.Coaxial
C.Crossover
D.Straight-through

正解:

Question No : 13
Which two of the following are true? (Choose two)

A.Telnet is preferred over SSH for security reasons.
B.SSH is a protocol that provides a secure remote access connection to network devices.
C.When using HyperTerminal to communicate over a TCP/IP network, the SSH protocol is used.
D.A Telnet network management connection is dropped when a router reboots.
E.Telnet is a protocol that provides a secure remote access connection to network devices.

正解:

Question No : 14
Which command indicates the amount of memory (NVRAM, RAM, and flash) in a Cisco device?

A.show diag
B.show environment
C.show inventory
D.show version

正解:

Question No : 15
ESD is the sudden and momentary electric current that flows between two different objects at different electrical potentials caused by direct contact or induced by an electrostatic field. Which three of the following tools should be used to avoid ESD? (Choose three)

A.ESD wrist strap
B.Latex gloves
C.Antistatic bag
D.Antistatic mat
E.Negative static mat
F.Negative static bag

正解:

Cisco 640-692 RSTECH 問題練習