Specialist - Implementation Engineer, PowerEdge Exam 試験
Question No : 1
Refer to the exhibit.
A technician tries to apply a BIOS update on a server through the iDRAC web interface using the Linux Dell Update Package file BIOS_2H4CC_LN_2.0.2.BIN. This results in the error shown in the exhibit.
What should the technician do to address this issue?
Question No : 2
What are benefits of installing the Dell iDRAC Service Module?
Reference: https://www.dell.com/support/manuals/us/en/19/idrac8-with-lc-v2.05.05.05/ ism_3.0.1_users_guide/in-band-support-for-idrac-snmp-alerts?guid=guid-85e59627-f95e-4c87-a4f4be4e1c774f00&lang=en-us
Question No : 3
A technician needs to troubleshoot a server. The OS had been operational, but an untrained person accessed the System Setup utility on the server and now the OS fails to load. The technician reboots the server, selects F2, accesses the System Setup utility, and selects System BIOS.
What two items should the technician verify in the System BIOS settings before reloading the OS?
Question No : 4
A user installed OME on a PowerEdge R640 server. OME has discovered and is currently monitoring another 30 remote PowerEdge 14G servers.
Each server has the following configuration:
- 2x CPUs
- 384 GB RAM
- 6x 1TB drives in a RAID 6 virtual disk
- No hot spare drive
- iDRAC9 Express license
At 9 PM on Monday evening, one of the remote servers has a disk failure but stays operational. The administrator monitoring OME does not find out about the issue until 5 PM in the following Friday. They place a support call to investigate why OME was not informed about the disk failure before then.
What is the reason for this issue not being reported to OME?
Question No : 5
After a disk rebuild operation, a technician needs to configure the system so that the rebuild process happens faster in the future, even at the expense of slowing users down.
How should the technician perform this task?
Question No : 6
A technician must update the firmware on a server, but has no network connectivity.
What can the technician use to update the BIOS and iDRAC/Lifecycle Controller firmware?
Question No : 7
Which tool provides automated Dell support case creation?
Question No : 8
A PowerEdge R640 server has a failure on one of its onboard NICs and sends an alert to technician support. The assigned technician needs to order a FRU to resolve the issue.
What action should the technician take?
Question No : 9
A technician needs to deploy a server into production and needs to verify that the firmware levels match corporate policy before putting the server on the business network.
Which method is recommended for verifying the firmware version of iDRAC and BIOS?
Question No : 10
A technician is sent-on-site to troubleshoot a server that reports errors during POST when rebooted. The following error message is displayed: “Correctable memory error rate exceeded for DIMM B4”. The LCD is amber. The server has a limited maintenance window so the technician needs to troubleshoot efficiently.
What should the technician do?
Question No : 11
A technician is ready to deploy a server. If a critical part such as the system board fails, they must be able to replace the system board, reconfigure components, and update the firmware revisions in the fastest possible time.
How should the technician meet this requirement?
Question No : 12
A server is being up as a VMware ESXi host. A technician needs to install the OS on an internal SD card. They install the SD card.
However, during OS installation, the SD card is not visible.
What should the technician do to fix the issue?
Reference https://www.google.com/url? sa=t&rct=j&q=&esrc=s&source=web&cd=16&cad=rja&uact=8&ved=2ahUKEwjj2eCyj6HeAhWyxYUKHW4 sBJYQFjAPegQIAhAC&url=https%3A%2F%2Fwww.sos.state.co.us%2Fpubs%2Felections% 2FVotingSystems%2FDVS-DemocracySuite%2Fdocumentation% 2FDell_Poweredge_R630_Owner_Manual.pdf&usg=AOvVaw2slkf77AG7CKsMUwdpiwVa
Question No : 13
A user has a server with only one processor installed with 6x 32 GB RDIMMs. A technician was asked to install a second processor. After installing the second processor, the technician finds that the second processor is not operational.
What should be done to make the second processor operational?
Question No : 14
A technician needs to update the iDRAC license on a PowerEdge R740 server from Express to Enterprise.
The server has the following components:
- 2x CPUs
- 384 GB RAM
- 6x 1 TB drives
- 1x PSU
The server is powered down but connected to active AC. The user wants it to stay powered down and not connect to any networks. No errors are presently displayed.
How can the technician upgrade the license?
Question No : 15
A technician is changing the iDRAC IP address from the static IP address 10.37.125.88 to DHCP on the technician’s PowerEdge R640 that does not have a front LCD. After completing this task, they are unable to determine which IP address was given to the iDRAC and they cannot reboot the server.
What method could the technician use to determine that IP address is assigned to the iDRAC?