Backup and Recovery - Avamar Specialist Exam for Implementation Engineers 試験
Question No : 1
What is the maximum number of nodes in a single AVE implementation?
Question No : 2
Which command instructs the EMC Avamar server to stop load balancing?
Question No : 3
Which command do you use to end all client activities when adding an EMC Avamar storage node?
Question No : 4
What is the result of specifying only one NTP server during an EMC Avamar server software installation?
Question No : 5
What is the minimum number of EMC Avamar active storage nodes required for a RAIN server?
Question No : 6
What is the minimum required random seek performance for a 2 TB EMC AVE?
Question No : 7
What is the lowest AVE version that will support an average daily change rate of less than 2 GB in a file server environment or 5 GB in a mixed environment?
Question No : 8
What is the minimum physical RAM requirement for a 0.5 TB installation of EMC AVE?
Question No : 9
How many hours does the benchmark test run in an AVE install?
Question No : 10
When fully configured and enabled in its default configuration, how frequently does the EMC Avamar Email Home feature send information to EMC?
Question No : 11
How large is the operating system partition for an AVE installation?
Question No : 12
A storage node on your EMC Avamar server has failed, and you are replacing it by using the spare node. What do you do to change the probe.xml node database?
Question No : 13
What does the iperf utility test?
Question No : 14
You have correctly executed the EMC Avamar network definition utility and rebooted all of the nodes in your Avamar server. To check that the nodes have been defined correctly, you execute the command mapall --all --user=root date.
Which nodes should respond by displaying the output of the command?
Question No : 15
You have completed a file transfer of the EMC Avamar software tar file to the Avamar server.What would you use to verify that the contents of the EMC Avamar software tar file are not corrupt?