NetWorker Specialist Exam for Storage Administrators 試験
新型 仕事休んだ：E20-597 最新真題を買う時、日本語版と英語版両方を同時に獲得できます。
Question No : 1
Refer to the exhibit.
What is the purpose of the Change Browse Time window when performing a recover in EMC NetWorker User?
Question No : 2
You want to perform a single file recovery from an EMC NetWorker NDMP backup of a Celerra NAS device. You are performing this restore from a Windows 2003 NetWorker server.
What recovery must be performed?
Question No : 3
In an EMC NetWorker environment, which access options are required for directed recoveries?
Question No : 4
Which EMC NetWorker settings control the amount of multiplexing?
Question No : 5
Which EMC NetWorker process reads and manages the port range information?
Question No : 6
What do you use to interpret the EMC NetWorker daemon.raw file?
Question No : 7
You are troubleshooting a problem with EMC NetWorker resources and some of the attributes are not being displayed in NetWorker Administration GUI.
What is done to display the advanced attributes?
Question No : 8
What needs to be configured to prevent possible name spoofing in an EMC NetWorker environment?
Question No : 9
An EMC NetWorker customer wants to relocate the Client File Index (CFI) for a client.
Which NetWorker resource must be updated with the new CFI location?
Question No : 10
A customer’s EMC NetWorker data zone has one NetWorker server and four NetWorker clients with two client resources configured for each client.
How many Client File Indexes are stored on the NetWorker server?
Question No : 11
Which EMC NetWorker command can be run to list all files currently tracked in the Client File Index for a particular client?
Question No : 12
Refer to the exhibit.
To which EMC NetWorker pool is the client save set backed up?
Question No : 13
You have a requirement to set up a NAS appliance into the EMC NetWorker environment. You have the remote username and passwords as well as the Fully Qualified Name (FQN) for the device and you wish to ensure that the NetWorker server can see the NDMP devices before the setup.
Which command should be used to do this?
Question No : 14
A customer is adding new tape devices to an EMC NetWorker server. The command is issued to scan for devices but does not find the new devices.
What is the most likely cause?
Question No : 15
What combination of simultaneous backups and recoveries is supported when using an advanced file type device in EMC NetWorker?