Huawei Certified Network Professional-WCDMA 試験
Question No : 1
Which ports must be opened between the PC and OMU that deploy the incident information collection tool?
Question No : 2
Which of the following boards provide clock recovery from the line? (Multiple Choice)
Question No : 3
16QAM is a high-order modulation method that uses phase and amplitude together to represent bit information. Each point is represented by 4 bits, and amplitude plus phase is used to represent a digital signal.
Question No : 4
Which IP address can be used by NodeB local maintenance terminal?
Question No : 5
One frame can configure more than one MPU subsystems.
Question No : 6
The inspection SOP report summary is provided by 5ummary Report feature of Mini-OMStar.
Question No : 7
What is the method for performing MTU detection on the NodeB side?
Question No : 8
Which is the preamble of Cch, 4, 3?
Question No : 9
Setting the working mode of E1/T1 to adjust the DIP switch is no better than to adjust it by the “SET E1T1” command of LMT.
Question No : 10
To improve the quality of the project and avoid the problem of intermodulation, what should be paid attention to during construction?
Question No : 11
One WRFU module can support 2 carrier or 4 carrier output.
Question No : 12
What information should you know and feedback when you encounter an accident at the scene? (Multiple Choice)
Question No : 13
In BTS3900, the WMPT board provides different physical port types for the Iub interface, including FE and 8-route E1T1.
Question No : 14
The DIP switch of the BSC6900 plug-in frame is located at the bottom of the back of the frame. Which of the following descriptions about bit 8 is correct?
Question No : 15
Which of the following statement about software management expert is wrong?