Huawei Certified Network Associate-LTE RNP&RNO 試験
Question No : 1
If the UE fails to switch, it is mostly characterized by dropped calls, RRC reestablishment, and so on.
Question No : 2
About the inter-frequency handoff based on the coverage, receive which of the following event will start GAP (inter-frequency) measurements?
Question No : 3
Regarding TA planning, which of the following statements is incorrect?
Question No : 4
Which of the following channel or signal is used to cell PCI identification and cell search process?
Question No : 5
Regarding the over-zone, overlapping coverage control, which of the following statements is wrong?
Question No : 6
In large, medium and small cities, many streets have tall buildings on both sides. To avoid time dispersion, the cell antenna azimuth of nearby base station cannot be installed on the street.
Question No : 7
The single-station verification test only needs to verify whether the cell status in the idle mode is normal.
Question No : 8
Which of the following format files can the Log file be converted to? (Multiple choice)
Question No : 9
Which of the following events is the basis for LTE synchronous frequency switching?
Question No : 10
LTE power control does not affect the coverage and capacity of the system.
Question No : 11
RSRP reference signal received power refers to the average signal power received by all REs of a Symbo bearer Reference Signa within the measured frequency bandwidth.
Question No : 12
LTE can obtain various interface signaling through LMT, M2000, and drive test tools.
Question No : 13
For the same-frequency switching scenario, which of the following parameters has little effect on the handover?
Question No : 14
Under the same coverage requirements, for the comparison between the adoption of f-band network and the adoption of d-band network, the number of stations required is;
Question No : 15
If the cell radius is 90 kilometers, which of the following should be used for the PRACH preamble format?