IT認証試験問題集
毎月、ITshikenは1500人以上の受験者が試験準備を助けて、試験に合格するために受験者にご協力します
 ホームページ / HP0-Y47 問題集  / HP0-Y47 問題練習

HP HP0-Y47 問題練習

Deploying HP FlexNetwork Core Technologies 試験

最新更新時間: 2019/05/15,合計22問。

平成から令和へ:HP0-Y47 最新真題を買う時、日本語版と英語版両方を同時に獲得できます。

実際の問題集を練習し、試験のポイントを了解し、テストに申し込むするかどうかを決めることができます。

さらに試験準備時間の35%を節約するには、HP0-Y47 問題集を使用してください。

 / 2

Question No : 1
Refer to the exhibit.



The five routers shown in the exhibit are successfully implementing OSPF on the interface shown in the exhibit. The exhibit also shows settings for OSPF areas and interface costs.
A network administrator enters these commands on Router 4 and Router 5:



How can the administrator ensures that Router 2 learns the route to 172.16.0.0/16 with next hop 10.0.0.6?

正解:

Question No : 2
An HP Provision switch port is implementing MAC Authentication (MAC-Auth) to a RADIUS server. A device connects to the port, and the switch submits a RADIUS Access-Request to the server. What correctly describes how the switch determines the username and password for the request?

正解:

Question No : 3
A company needs a simple guest access solution. On each HP Provision access layer switch, the network administrator (Web-Auth) to an external Web server. Which guidelines must the administrator follow while setting up the Web server?

正解:

Question No : 4
What distinguishes an HP switch with a CLOS fabric from an HP switch with a crossbar fabric?

正解:

Question No : 5
HP Comware Switch 1 connects to switch 2 on GigabitEthernet 1/0/1. Swutch 2 implements an inbound rate limit of 600 Mbps. The network administrator wants switch 1 to buffer traffic that exceeds the Switch 2 rate limit of 600 Mbps and send the traffic at 600 Mbps. All traffic has the same 802.1p priority and is forwarded in priority queue 2.
What should the administrator apply to the Switch 1 interface GigabitEthernet 1/0/1?

正解:

Question No : 6
Two HP 10500 Series Switches connect on a 10G fiber link. One of the two fibers in the link breaks, and a broadcast storm occurs. How could a network administrator prevent a problem like this from happening again?

正解:

Question No : 7
Refer to the exhibit.



A network administrator up a remote mirroring on the HP Comware switches in the exhibit. The administrator must define several port while entering mirroring-group commands on these switches. Which port should be the reflector port (sometimes called monitor-egress port)?

正解:

Question No : 8
A company needs a simple authenticate solution for guests. The HP Comware access layer switches will implement portal authentication (or Web-Auth). The network administrator wants the switch to host the login web page on an IP address that not used for any other purpose.
What should the administrator do to accomplish this goal?

正解:

Question No : 9
Refer to the exhibit.



These three routers are currently configured for BGP. They do not apply any routing policy in terms of BGP on routes or attributes advertised to an received from peers. How can the network administrator for Router 1 cause Router 1 to advertise 192.0.2.0/24 to Router 2 and Router 3?

正解:

Question No : 10
Refer to the exhibit.



An HP Comware Switch connects to Voice over (VoIP) phones. The phones connect to user’s computes, so each switch port connects a computer and a phone.
These are the specifications:
-The VLAN for data traffic is VLAN3 -The VLAN for traffic VoIP is VLAN11 -The phones support Link Layer Discovery Protocol (LLDP) Media Endpoint Detection (MED).
The network administrator wants to use LLDP-MED to advertise the voice VLAN ID and priority settings to the phones. The phones will then send tagged traffic in that VLAN. The switch should not check the incoming traffic’s MAC address against its voice OID list. The exhibit shows the applicable switch port configuration.
Which additional step must the administrator complete to accomplish this?

正解:

Question No : 11
A company uses 802.1X authentication to force users to authenticate to connect to the network. The company uses HP IMC User Access manager (UAM) as the RADIUS server. The company wants to assign users to VLANs based on their identity. For example, contractor should be assigned in VLAN 20. Assume that VLANs are extended correctly across the network infrastructure.
Where does a network administrator configure the VLAN policy?

正解:

Question No : 12
How does virtual output queuing (VoQ) help switches avoid head-of-line blocking and enhance throughput?

正解:

Question No : 13
A company uses 802.1X authentication to force users to connect to the network. The company uses access layer switches to enforce the 802.1X authentication and HP IMC User Access manager (UAM) as the RADIUS server.
The customer requires switches to apply a specific settings to contractor use connections. The network administrator checks the switch documentation and determines that this settings uses a vendor-specific attribute (VSA). The administrator check UAN and verifies that it has this VSA defined on it.
How does administrator configure UAM to apply the correct setting?

正解:

Question No : 14
Refer to the exhibit.



A user connects a device to GigabitEthernet 1/0/1 on switch. The device does not have an 802.1X supplicant. One minute passes. How does the switch port handle the client?

正解:

Question No : 15
A network administrator wants to configure Open Shortest Path (OSPF) MD5 authentication on VLAN 100 on an HP ProVision switch. The administrator has created a global MD5 key chain with an ID and key string that matches the neighbor’s. which additional step must the administrator complete to accomplish this?

正解:

 / 2