IT認証試験問題集
毎月、ITshikenは1500人以上の受験者が試験準備を助けて、試験に合格するために受験者にご協力します
 ホームページ / HP0-Y52 問題集  / HP0-Y52 問題練習

HP HP0-Y52 問題練習

Applying HP FlexNetwork Fundamentals 試験

最新更新時間: 2019/05/15,合計27問。

平成から令和へ:HP0-Y52 最新真題を買う時、日本語版と英語版両方を同時に獲得できます。

実際の問題集を練習し、試験のポイントを了解し、テストに申し込むするかどうかを決めることができます。

さらに試験準備時間の35%を節約するには、HP0-Y52 問題集を使用してください。

 / 2

Question No : 1
Refer to the exhibit.



A network administrator is upgrading the operating system on an HP Comware switch. When copying the new image from a TFTP server to the flash of the switch, the process fails because there is not enough flash to store the new operating system. The new operating system is 3.2MB in size. The administrator then executes the commands shown in the exhibit above.
Which action should the administrator perform to solve this problem?

正解:

Question No : 2
Which HP device or port type can modify, read, and respond with frames that include 802.1Q VLAN tags?

正解:

Question No : 3
Refer to the exhibit.



A network administrator enters the command shown in the exhibit to check the VLANs on an HP ProVision switch interface. The administrator wants to discover which VLANs are tagged and untagged on the port.
What can the administrator do to accomplish this?

正解:

Question No : 4
A network administrator is managing an HP Comware switch from the CLI.
Which action can the administrator only perform in User view?

正解:

Question No : 5
HOTSPOT
Match the description with the 802.11 standard. (Each option may be used only once.)



正解:

Question No : 6
A network administrator enters this command on an HP ProVision switch with IP routing enabled:
ip route 0.0.0.0/0 10.1.1.1 metric 10 distance 10
This is the only IP route to 0.0.0.0/0 on the switch.
What is the effect?

正解:

Question No : 7
Which statement is true about wireless technologies?

正解:

Question No : 8
Which HP software platform provides centralized network management, monitoring, and configuration of wired and wireless network infrastructure devices, as well as traffic monitoring, user management, and other capabilities?

正解:

Question No : 9
Refer to the exhibit.



Assume that Student A’s ARP table is empty. Student A is preparing to send an FTP packet to FTP Server B and needs to discover the proper destination MAC address.
For which IP address does Student A send an ARP request?

正解:

Question No : 10
Refer to the exhibit.



The switches in the exhibit are all HP Comware switches that run Multiple Spanning Tree Protocol (MSTP). The network administrator wants to ensure that each switch-to-switch link is in its own subnet. The administrator also wants to make sure that all of the links are available for routing during normal operation.
How should the administrator configure the physical switch-to-switch interfaces to accomplish these goals?

正解:

Question No : 11
All of the switches in Exhibit 1 are routing switches. Exhibit 2 shows the routes configured on these switches. The direct (connected) routes are not shown, but assume that links are configured with the IP addresses shown in Exhibit 1.



The network administrator wants to protect communications between clients and servers in case Link 1 fails.
What should the administrator do to protect these communications in this failover situation?

正解:

Question No : 12
Refer to the exhibit.



The network administrator has configured this port to permit all VLANs. The output in the exhibit indicates that the port is only passing VLANs 1 and 11. The administrator wants the port to pass VLAN 12 as well.
What should the administrator do to accomplish this?

正解:

Question No : 13
A server connects to a port on an HP Comware switch.
The network administrator wants to ensure that:
- the port remains forwarding during Multiple Spanning Tree Protocol (MSTP) topology changes, and
- changes in the port status do not cause MSTP topology changes.
Which statement describes how the administrator can accomplish this?

正解:

Question No : 14
Refer to the exhibit.



The exhibit shows partial output of the HP Comwaredisplay ip routing-table command. Note the Pre or preference column.
On an HP ProVision switch, what is the corresponding term used for the Pre column in the Comware output shown in the exhibit?

正解:

Question No : 15
What is one difference between Network Segment-based discovery and ARP-based discovery on HP Intelligent Management Center (IMC)?

正解:

 / 2