NetApp Certified Support Engineer 試験
Question No : 1
A Linux client is experiencing low throughput when reading a very large file using NFS. Network counters suggest there is packet drop in the network. To confirm whether dropped packets affect the Linux client, you are collecting network traces from the affected systems.
In this scenario, which two actions would be used? (Choose two.)
Question No : 2
Your storage system has experienced a double-disk failure. When is this scenario considered to be in double-degraded mode?
Question No : 3
You just set up a new clustered Data ONTAP 8.3 environment and want to monitor volume performance.
Which two commands or products would help you accomplish this task? (Choose two.)
Question No : 4
You have an aggregate with 10 TB of free space. You create a 5 TB volume with space-guarantee set to none and fractional reserve set to 0. Inside the volume, you create a 100 GB space-reserved LUN.
In this scenario, how much free space is left in the aggregate?
Question No : 5
A 2 node cluster (Node-1 and Node-2) has suffered a takeover event. The down node (Node-1) is currently waiting for giveback. However, it is unsure if the node will boot successfully. The client suffer any data outage.
Which command would you use to perform the giveback?
Question No : 6
SnapDrive for Windows has been installed and configured on a VMware virtual machine. The virtual machine has been configured with raw device mappings (RDMs) that are mapped to LUNs on a NetApp storage controller. The RDMs can be seen as connected disks in Windows Disk Management.
However, SnapDrive is not enumerating the RDMs.
Which action will solve the problem in this scenario?
Question No : 7
You are trying to determine why AutoSupport notifications are not being sent.
Which two types of output would be used first to solve this problem? (Choose two.)
Question No : 8
A customer explains that their V3170 NetApp controller has failed over and they do not know what to do next.
In this scenario, what information should the customer collect from the Remote LAN Module (RLM) and send to you? (Choose two.)
Question No : 9
You have a 6-node cluster with six identical controllers. You are upgrading from clustered Data ONTAP 8.3.1 to clustered Data ONTAP 8.3.2. From the Upgrade Advisor, you downloaded the upgrade plan.
In this scenario, which two steps are part of that plan? (Choose two.)
Question No : 10
A customer mentions that their Windows users cannot access clustered Data ONTAP 8.3.1 CIFS shares. The users see "access denied" on the Windows side. Host name resolution is working and properly resolves IP to host name and host name to IP and the customer can ping using host name and IP.
In this scenario, which statement describes the problem?
Question No : 11
A customer cannot create a new volume from OnCommand System Manager.
Which two clustered Data ONTAP daemons would be at fault in this scenario? (Choose two.)
Question No : 12
A customer has replaced both interconnect cables on a FAS3240 HA pair with IOXM because they were damaged. After replacing the cables, the customer receives the error shown below.
"HA interconnect port 1 of this appliance seems to be connected to port 2 on the partner appliance."
In this scenario what is the cause of this error?
Question No : 13
You receive the AutoSupport message, "CONTROLLER TAKEOVER COMPLETE PANIC" from a FAS3250 controller. You suspect a hardware issue. A core file was written to disk.
In this scenario, which two actions would you perform to obtain more information? (Choose two.)
Question No : 14
Click the Exhibit tab.
Your customer's MetroCluster controllers have generated AutoSupport notifications with a "DISK REDUNDANCY FAILED" message.
Referring to the exhibit, which component is causing the problem?
Question No : 15
You are creating a disk-partitioned root aggregate.
Which two rules are enforced automatically when accomplishing this task? (Choose two.)