Fortinet Network Security Expert 4 Written Exam - FortiOS 5.4 試験
Question No : 1
Which statements are correct based on this output? (Choose two.)
Question No : 2
Which configuration steps must be performed on both units to support this scenario? (Choose three.)
Question No : 3
Which statement is correct based on this configuration?
Question No : 4
How to configure Collector agent settings?
Question No : 5
A client workstation is connected to FortiGate port2. The Fortigate port1 is connected to an ISP router. Port2 and port3 are both configured as a software switch.
What IP address must be configured in the workstation as the default gateway?
Question No : 6
What inspections are executed by the IPS engine? (Choose three.)
Question No : 7
Which of the following statements are true when using Web Proxy Auto-discovery Protocol (WPAD) with the DHCP discovery method? (Choose two.)
Question No : 8
A FortiGate is operating in NAT/Route mode and configured with two virtual LAN (VLAN) sub-interfaces added to the same physical interface.
Which statement about the VLAN IDs in this scenario is true?
Question No : 9
In a high availability (HA) cluster operating in active-active mode, which of the following correctly describes the path taken by the SYN packet of an HTTP session that is offloaded to a secondary FortiGate?
Question No : 10
Which of the following statements are true? (Choose two.)
Question No : 11
Which statement about this configuration is correct?
Question No : 12
Which statements about FortiGate inspection modes are true? (Choose two.)
Question No : 13
What does the configuration do? (Choose two.)
Question No : 14
Why must you use aggressive mode when a local FortiGate IPsec gateway hosts multiple dialup tunnels?
Question No : 15
What does the command diagnose debuf fsso-polling refresh-user do?