Administration of Veritas NetBackup 7.7 and NetBackup Appliances 2.7 試験
Question No : 1
Which interface is pre-configured with the 192.168.229.233 IP address?
Question No : 2
Which two actions should an administrator take to allow NetBackup to manage the allocation of volumes to volume pools? (Select two.)
Question No : 3
Which bonding mode requires configuration on the network switch?
Question No : 4
An administrator runs the following command on the Master Server to test connectivity to a client:
bpte3tbpcd -client clientA
The administrator receives the following message:
16> bptestbpcd main: Function ConnectToBPCD (clientA. failed: 25 cannot; connect on socket)
Which two reasons may cause the error message? (Select two.)
A. an incorrect entry for the Master Server in the client's hosts file
B. the NetBackup processes on the client are stopped
C. the Master Server is unknown to the client
D. an incorrect entry for the client in the Master Server's hosts file
E. vnetd is stopped on the Master Server
Question No : 5
Which NetBackup command is used to report the potential free space of AdvancedDisk storage units?
Question No : 6
Which status code applies only to disk storage units?
Question No : 7
An administrator needs to duplicate a backup that completed successfully earlier that same day.
How can this be accomplished?
Question No : 8
An administrator needs to decrease the total amount of time required to back up a UNIX file server, but requires a full backup every night for recovery purposes.
How should the administrator proceed?
Question No : 9
An administrator tries to suspend an active job from the NetBackup Activity Monitor, but discovers that the option is grayed out.
What is preventing the administrator from suspending the job?
Question No : 10
The following storage lifecycle policy was used to back up data from a client.
Storage Lifecycle Policy Backup to Advanced Disk
Duplication to tape
Duplication to Advanced Disk
How should an administrator restore data from the tape using NetBackup?
Question No : 11
What are two possible causes for job failure when a Windows policy is configured to use Accelerator? (Select two.)
Question No : 12
Which policy directive(s) should an administrator place in the Backup Selections tab to ensure the system is protected when backing up a Windows server?
Question No : 13
Which command can be used to recover the NBDB from the staging location?
Question No : 14
Refer to the exhibit.
What is the outcome of the policy shown in the exhibit?
Question No : 15
An administrator needs to store secure tape copies of protected data to an offsite location. How can the administrator automatically eject tape media daily and create detailed reports?